Table Of Contents - NAPCO GEMINI GEM-P1632 Programming Instructions Manual

WI1148B 10/06

TABLE OF CONTENTS

SYSTEM PROGRAMMING OPTIONS ..................................... 4
Introduction ......................................................................... 4
Downloading From a Computer ........................................... 4
EASY MENU DRIVEN PROGRAM MODE ............................... 5
Dealer Program - Preliminary Information ........................... 5
Accessing Dealer Program Mode ........................................ 5
Customizing a Default Program ........................................... 5
Easy Program Menu:
GEM-RP2ASe2/GEM-K2AS KEYPAD ........................ 6
GEM-RP3DGTL/GEM-K3DGTL and
GEM-RP4RFC/GEM-K4RF KEYPAD ................... 13
DIRECT ADDRESS PROGRAM MODE ................................... 20
Keypad Programming Overview .......................................... 20
Accessing Direct Address Program Mode ........................... 20
Keypad Address Program Mode Display ............................. 21
Direct Address Program Mode Keypad Commands ............ 21
Direct Address Programming Example ................................ 22
Conventions Used in this Manual ........................................ 23
SYSTEM DELAYS & TIMEOUTS ........................................ 24
SYSTEM OUTPUT TIMEOUTS .......................................... 25
DOWNLOAD/CALLBACK OPTIONS .................................. 25
PAGER FORMAT OPTIONS ............................................... 25
SYSTEM OPTIONS ........................................................... 26
GLOBAL AMBUSH CODE .................................................. 26
SYSTEM OPTIONS ............................................................ 27
CS RECEIVER OPTIONS ................................................... 30
CS SUBSCRIBER ID OPTIONS ........................................ 31
CS SYSTEM REPORTING OPTIONS ................................ 32
CS AREA & SYSTEM REPORTING OPTIONS ................... 32
CS ZONE REPORTING OPTIONS .................................... 33
CS USER REPORTING OPTIONS .................................... 34
Refer to accompanying GEM-P1632 Installation Instructions (WI808) for installation information.
NOTE: THESE PROGRAMMING INSTRUCTIONS ARE INTENDED AND WRITTEN FOR THE PROFESSIONAL INSTALLER HAVING SUITABLE
EXPERIENCE AND INSTALLATION EQUIPMENT.
COMPUTER WITH NAPCO PCD-WINDOWS SOFTWARE. AFTER PROGRAMMING, BE SURE TO RUN THE PCD-WINDOWS ERROR-CHECK
UTILITY TO GUARD AGAINST PROGRAMMING CONFLICTS FOR THE TYPE OF SERVICE SELECTED FOR THE INSTALLATION.
L
NAPCO Security Systems
CS USER REPORTING OPTIONS .....................................35
EZM GROUP OPTIONS .....................................................36
AREA ARMING OPTIONS ..................................................36
AREA BELL CONTROL OPTIONS .....................................37
KEYPAD OPTIONS ............................................................41
TEMPERATURE DISPLAY AT KEYPAD ............................42
ZONE OPTIONS - ZONES 1 TO 16 ....................................43
ZONE OPTIONS - ZONES 17 TO 32 ..................................44
EXTERNAL RELAY CONTROL ..........................................47
RF RECEIVER & SUPERVISORY TIMER OPTIONS .........50
CLEAR PROGRAM OPTIONS ...........................................51
USER PROGRAM MODE .........................................................51
Preliminary Information ........................................................51
Accessing User Program Mode ............................................51
User Codes ..........................................................................52
KEYPAD CONFIGURATION MODE .........................................53
Keypad Installation ...............................................................53
Configuring the Keypads ......................................................53
ALPHABETICAL INDEX ............................................................54
ADDRESS NUMBER LOCATION INDEX ..................................59
GEM-P1632 WIRING DIAGRAM ...............................................64
THE UNIT IS DESIGNED TO BE PROGRAMMED USING AN IBM-COMPATIBLE
X
GEM-P1632 Programming Instructions
Page 3