Nortel Internet BWA System 3200 User Manual page 63

Procedure 6-5 (continued)
Aligning the antenna of the Internet BWA System 3200
Step
15
16
17
Perform a fine antenna alignment
18
19
20
Action
Place marks on the threads of the antenna mounting plate to identify the main
and side lobes.
After identifying both the main and side lobes, position the antenna assembly
to the main lobe mark.
Tighten the elevation adjustment screws by hand.
Use a 15mm / 1/2" open wrench to slightly move the azimuth adjustment
screws for a maximum RSSI reading.
Use a 15mm / 1/2" open wrench to slightly move the elevation adjustment
screws for a maximum RSSI reading.
Repeat this procedure at the far-end terminal.
—end—
User guide NTXXXXXX Rel 3.0 Draft October 2000
Installation and commissioning procedures 6-23