Nortel Internet BWA System 3200 User Manual page 49

Procedure 6-2 (continued)
Installing the Internet BWA System 3200 on a pole
Step
7
Figure 6-4
Position of the mounting assembly
Pole clamp
(2 places)
8
9
10
11
Action
Position the azimuth adjustment plate (P/N 101488-1) to the pole in the
position that refers to the direction of the antenna as shown in
Azimuth
adjustment
rod
To attach the azimuth adjustment plate to the pole, use the U-bolt (100441-1),
the flat washers, the split lock washers and the the 3/8 x16 bronze nuts (refer
to Figure 6-2 on page
Position the antenna mounting plate on the opposite side of the azimuth
adjustment plate as shown in
The azimuth adjustment rod attaches to the antenna mounting plate at the
factory.
• remove the 3/8 hex nut, the flat and the split lock washers from the
azimuth adjustment rod
• insert the azimuth adjustment rod into the slot of the azimuth adjustment
plate (see Figure 6-4).
Replace and tighten the 3/8 hex nut, the flat and split lock washers on the
azimuth adjustment rod.
—continued—
User guide NTXXXXXX Rel 3.0 Draft October 2000
Installation and commissioning procedures 6-9
Azimuth adjustment
plate
6-7).
Figure 6-4.
Figure 6-4.
MOP0093p.eps
Elevation
adjustment rod
Brass
cylinder
Antenna mounting
plate
Direction of
Antenna