Nortel Internet BWA System 3200 User Manual page 58

6-18 Installation and commissioning procedures
Procedure 6-4 (continued)
Setting up the Internet BWA System 3200
Step
Trouble clearing the communication between the HHT and the ODU
7
Set the transmit mute function to "ON"
8
9
10
11
Internet BWA System 3200
Action
If you cannot establish communication between the HHT and the ODU.
a. Confirm the address and enter it again.
b. Check the DC power to the outdoor unit (ODU).
— Check the cable
— Check the cable connector on the ODU
— Check the power source.
c. Disconnect and inspect both the ODU and the hand-held wireless
antennas.
d. Attach the antennas again
e. Repeat to step 3 to
f. Replace the whip antennas with the RG-58 coaxial cable:
— connect the coaxial cable between ODU and the HHT
— repeat step 3
g. If the communications channel cannot be established, contact Customer
Support (see "Warranty and field support" on page
From the Near Radio menu, press the ENTER key.
The HHT displays the Control submenu.
From the Control submenu, press the ENTER key.
The HHT displays the first parameter in the Control submenu (Tx Freq) and
the following message appears on the display:
Set TX
Press the ARROW key until the transmit RF power command Set Pwr
appears on the display.
Press the ENTER key.
The current transmit RF power setting appears on the display
—continued—
NTXXXXXX Rel 3.0 Draft October 2000
step 5.
to step 5.
4-5)