Nortel Internet BWA System 3200 User Manual page 61

Procedure 6-5 (continued)
Aligning the antenna of the Internet BWA System 3200
Action
Step
Perform the horizontal antenna alignment
1
2
3
4
5
6
Figure 6-8
Location of the azimuth adjustment screws
7
8
Action
Establish communication with personnel on the far-end of the link.
From the HHT, go to the Near End | Status menu.
Press the ENTER key to access the parameters in the Status submenu.
The following message appears on the display:
Get TX
Press the ARROW key until the RSSI command appears on the display.
Press the ENTER key.
The current setting appears on the display. The HHT remains ON as you
monitor RSSI and BER status.
Loosen the azimuth adjustment screws (see
Azimuth adjustment screws
Use a compass and move the antenna horizontally within the direction of the
far-end antenna.
While you monitor the RSSI on the HHT, slowly move the antenna through the
complete horizontal adjustment range.
—continued—
User guide NTXXXXXX Rel 3.0 Draft October 2000
Installation and commissioning procedures 6-21
Figure 6-8).
MOP0096p.eps
Polarization
indicators