Nortel Internet BWA System 3200 User Manual page 59

Procedure 6-4 (continued)
Setting up the Internet BWA System 3200
Step
12
13
14
Verify and set the link ID
15
16
17
18
19
20
21
Action
To change the Set Pwr setting,
a. Use the keypad to enter the required transmit RF power output (Range
+2 to +17 dBm). For example, to insert 2dBm, enter:
Set Pwr: 2dBm
b. press the ENTER key.
Press the MENU key to return to the Control menu.
Press the MENU key again to return to the Far End menu.
Use the following steps to establish link identification when multiple Radio
links are located at the same site.
Use the following steps to set the near-end and far-end terminals to the same
Link ID number.
Go to the Near End | Control menu.
The following message appears on the display:
Set TX
Press the ARROW key until the Set Link ID (FAW) command appears on the
display.
Press the ENTER key.
The current setting appears on the display.
To change the Set Link ID (FAW) setting:
a. Use the keypad to enter an ID number (Input range 0-7).
b. Press the ENTER key.
Press the MENU key to return to the Control menu.
Press the MENU key again to return to the Near End menu.
Repeat step 15 to step 20
terminals have the same "Link ID" number.
—end—
User guide NTXXXXXX Rel 3.0 Draft October 2000
Installation and commissioning procedures 6-19
for the far-end terminal to make sure that both