Terminal Mode - NEC UNIVERGE SV9500 User Manual

• Manual Connection
STEP 1: Be sure to confirm that Bluetooth
tion is ON (The Connect key lights red).
STEP 2: Press the Connect key less than 3 seconds.
STEP 3: The terminal sends a connection request to
the most recently connected mobile phone.

STEP 4: Bluetooth connection between the terminal
and the mobile phone will be established.
• To switch the call by using Bluetooth
feature
When you leave the desk while talking in Mobile
Phone Mode, you can switch from the call with ter-
minal handset to the call with mobile phone.
For the details of Mobile Phone Mode, see
NAL MODE.
STEP 1: Press the Connect key less than 2.5 seconds.
This operation is canceled by pressing the
Connect key again.
STEP 2: The call switches from the terminal to the mo-
bile phone. To switch the call using mobile
phone, refer to the manual of your mobile
phone.

TERMINAL MODE


connec-
For DT830G, there are two types of terminal mode
called "Wired Telephone" mode and "Mobile Phone"
mode. The terminal starts up on "Wired Telephone"
mode by default.
•
Enables the terminal to make a voice call as a sta-
tion in the system.
•

Enables the terminal to make a voice call for mo-
bile phone.
Note
TERMI-
Note
220
Wired Telephone Mode
Mobile Phone Mode
When the terminal is placed in Security mode, the Blue-

tooth feature will be OFF even if the terminal is in
busy/idle state. After that, the terminal mode switches
to the Wired Telephone Mode.
When the Security mode is canceled, the Bluetooth
feature will be ON. However, the terminal mode will be
the Wired Telephone Mode.
