Table of Contents
Advertisement
Symptom
Cannot be used as
an NDI device.
Connection with external devices
External synchronization
Symptom
An external sync signal suitable for the
configured video signal format is not
Cannot
being input.
synchronize to
external source.
Unit is double-terminated.
Tally
Symptom
The tally lamp brightness is set to Off.
The recording/tally lamp is configured as a
Tally lamp
recording lamp.
does not
light up.
RM-IP500 is connected and VISCA over IP is
disabled.
The OPTION connector connection is incorrect
or the target pin is not short-circuited to GND.
Cause
An NDI|HX license is not
installed.
Cause
Cause
5-041-957-11(1) Copyright 2022 Sony Corporation
Install an NDI|HX license. You can check whether there is an
NDI|HX license using [Stream] > [Stream] > [Stream Setting]
> [NDI|HX] > [License] in the web menu.
Input an external sync signal suitable for the
configured video signal format.
The unit has a built-in 75 Ω terminator. Connect
directly to a signal source (one-to-one) or use a
distributor (splitter).
Set the appropriate brightness using [Technical] >
[Tally] > [Tally Lamp Brightness] in the web menu.
Configure the recording/tally lamp to function as a
tally lamp as described in
Signal."
Set SETUP switch 3 to the ON position on the
connector block.
Short-circuit pin 7 or pin 8 of the OPTION connector
to GND as described in
436
Solution
Solution
Solution
"Connecting a Tally
"Connecting a Tally
Signal."
Advertisement
Table of Contents
