Sony ILME-FR7 Help Manual page 411

Help Guide
Interchangeable Lens Digital Camera
ILME-FR7 / ILME-FR7K
Connecting an RM-IP500 Remote Controller
Set SETUP switch 3 of the unit to the ON position to enable VISCA over IP communication.
1
Note
The switch setting is applied when the unit is next turned on.
Connect the RM-IP500 to the same network as the unit.
2
Follow the procedure in the RM-IP500 operating instructions to configure VISCA over IP (LAN) connection
3
on the RM-IP500.
Assign this unit using RM menu > AUTO IP SETUP > ASSIGN CAM.
Assign functions of this unit to buttons and knobs, as required, using the following RM menu items of the
4
RM-IP500.
SW ASSIGN
AE CONFIG2
WB MODE
For details about assigning functions, refer to the operating instructions for the RM-IP500.
5-041-957-11(1) Copyright 2022 Sony Corporation
411