Table of Contents
Advertisement
Shooting
Camera
Symptom
Image looks distorted at the start
and end of pan/tilt operation.
Angle of view changed without
user operation.
Cannot operate the focus, zoom,
or iris.
Pan/tilt
Symptom
Cannot reset the
The pan/tilt lock lever is in
pan/tilt.
the LOCK position.
The camera block is out of
balance.
A lens that does not
support pan/tilt is
attached.
Camera does not
stop in the
Cannot execute pan/tilt
expected position.
reset.
An unexpected force was
applied to the camera
head, causing a pan/tilt
control error.
Camera does not
return to the front
Ceiling mount mode has
when the [Pan-Tilt
been activated.
Home] button is
pressed.
Pan/tilt range limit is
configured.
Pan/tilt operation
An unexpected force was
is restricted.
applied to the camera
head, causing a pan/tilt
error.
The ceiling mount mode
setting is different than the
Pan/tilt operation
actual mounting state.
moved in the
Settings related to the
opposite direction.
pan/tilt direction were
changed.
The image may be distorted if the image
stabilization function of the lens is turned on.
Lens breathing occurred.
The settings of switches on the lens may be
incorrect.
Cause
Slide the pan/tilt lock lever to the UNLOCK position.
Move the camera block forward/rearward to an appropriate position
as described in
Refer to the lens compatibility information and attach a lens that
supports pan/tilt, and then turn the unit on again.
Execute a pan/tilt reset as described in
Set [Pan-Tilt] > [P/T Direction] > [Ceiling] in the web menu
according to the actual installation, and then turn the unit on again.
When mounted on a ceiling, the connector block will be at the front
of the camera.
Clear the pan/tilt range limit settings, as required, as described in
"P/T Range
Execute a pan/tilt reset as described in
Set [Pan-Tilt] > [P/T Direction] > [Ceiling] in the web menu
according to the actual installation.
Check the [Pan-Tilt] > [P/T Direction] settings in the web menu.
Cause
Solution
"Attaching a
Lens," and then turn the unit on again.
Limit."
432
Solution
Turn off the image
stabilization function of the
lens.
See
"Breathing
Compensation."
See
"Checking the Lens
Switches."
"Resetting the
Pan/Tilt."
"Resetting the
Pan/Tilt."
Advertisement
Table of Contents
