Table of Contents
Advertisement
Symptom
Image does not
The pan/tilt operation
move smoothly at
acceleration/deceleration
the start and end
of pan/tilt
setting is too high.
operation.
The camera block is out of
balance.
The ramp curve
Pan/tilt operation
(acceleration/deceleration)
stopped.
setting is too high for the
attached lens.
A large lens is being used.
The lens support pedestal
attachment screw clamp
lever hits the camera.
Unit is obstructed
when the pan/tilt is
The lens support clamp
operated.
lever hits the camera.
The camera head lock
lever hits the camera.
The camera is out of
balance.
The ramp curve
(acceleration/deceleration)
Abnormal noise
setting is too high for the
occurs during
attached lens.
pan/tilt operation.
The camera head is not
fixed in position and there
is a moving noise during
operation.
Saving and loading a
preset is not available
Cannot save or
when [Zoom Type] is set
load a preset.
to [On(Clear Image
Zoom)].
The pan/tilt operation is
unavailable while the
thumbnail screen is
displayed and during
The framing
playback.
control panel of
the Web App is
The pan/tilt operation is
grayed out and
unavailable when the
cannot be
camera image cannot be
operated.
displayed in the Web App.
The pan/tilt lock lever is in
the LOCK position.
Cause
Reduce the pan/tilt operation acceleration/deceleration setting to
make the motion at the start and end of pan/tilt operation smoother
using [Pan-Tilt] > [P/T Acceleration] > [Ramp Curve] in the web
menu or camera menu. Note that this will mean that the lens takes
longer to reach the maximum speed.
Move the camera block forward/rearward to an appropriate position
as described in
If a large lens is attached, reduce the value of [Pan-Tilt] > [P/T
Acceleration] > [Ramp Curve] in the web menu or camera menu.
Contact your Sony support representative.
Turn the lens support pedestal attachment screw clamp lever so
that it is pointing up.
Turn the lens support clamp lever so that it is pointing up.
Check that the camera head lock lever is fully in the LOCK
position.
Move the camera head forward/rearward to an appropriate position
so that the slide base is horizontal.
If a large lens is attached, reduce the value of [Pan-Tilt] > [P/T
Acceleration] > [Ramp Curve] in the web menu or camera menu.
Set the camera head lock lever to the LOCK position.
Set [Technical] > [Zoom] > [Zoom Type] to [Optical Zoom Only] in
the camera menu.
Exit the thumbnail screen display or stop playback.
See "Web App" in "Troubleshooting."
Slide the pan/tilt lock lever to the UNLOCK position.
Solution
"Attaching a
Lens," and then turn the unit on again.
433
Advertisement
Table of Contents
