Connecting the Host and CS 1000 4-Slot Cradle
To connect the CS 1000 4-Slot Cradle to a host computer for communications:
1. Plug the RS-232 serial cable's DB-25 connector in the cradle's communication port.
The port is located on the back right-hand side of the single-slot cradle, and on the
left side of the 4-slot cradle.
Figure 2-2. Plugging Serial Connector into Single-Slot and 4-Slot Cradles
2. Connect the cable's other DB-25 connector to the host's serial (COMM) port.
3. Connect the power supply cord's round connector to the cradle's power port
2-3).
The single-slot cradle's power port is on the back right-hand side, above the
communications port; use power supply p/n 50-14000-045.
One Slot
Cradle Setup
Four-Slot
(Figure
2-3