Table of Contents
Advertisement
4. Slide an appropriately sized o-ring onto your middle finger, or onto both your middle
and ring fingers, and secure using the strap on the front of the mount.
5. Pull the hand strap snug, then use the velcro to secure the strap. Place the lip on the
front of the terminal mount over the velcro area on the scanner mount to secure the
two units together.
6. Wrap the trigger cable around the side of the scanner, next to your index finger, and
secure using the velcro loop on the side of the mount.
7. Slide the trigger mount on your index finger, with the button positioned next to your
thumb, and adjust the velcro strap.
Figure 5-22. Placing Trigger Mount on Finger
Or
Figure 5-20. Attaching O-Ring
Hand Mount
Velcro Strap
Figure 5-21. Securing Strap
Operating the WSS 1000
5-11
Advertisement
Table of Contents
Troubleshooting
