Initializing The Wwc 1040 - Symbol WSS 1000 Product Reference Manual

Initializing the WWC 1040

Note: This section covers specific settings required on first booting the
WWC 1040, out of the box. For a complete review of the CFG24
screens, refer to
Utilities.
To initialize a WWC 1040 which has LWP.HEX version 3.03 or greater loaded:
1. Insert a charged battery in the WWC 1040. Refer to
Battery Charging
2. Cold boot the WWC 1040.
a. Press <Æ + ENTER>.
b. Press and release the Power button.
c. Release <Æ + ENTER>.
3. The WWC 1040 loads software, then displays the Spectrum24 Configurator
(CFG24) menu, shown in
Note: On subsequent initializations, type CFG24 at the DOS prompt to
bring up the configurator.
Appendix C, Spectrum24 Network and Flash Disk
for instructions on charging and installing a battery.
Figure 4-1.
CONFIGURATOR 1.XX
View config
params
Net Id
Subnet Mask
Default Router
Terminal IP
Address
Diversity
Terminal Sleep
Mode
Boot Mode
Figure 4-1. CFG24 Main Menu
Spectrum24 RF Terminal Setup
Chapter 2, Cradle Setup and
4-3