Switching Cables; Connecting To A Host - Symbol LS 1004 Product Reference Manual

Switching Cables

Different cables are required for different hosts. To change the scanner cable:
1. "Unlock" the cable by twisting to the right.
2. Pull the cable out of the receptacle on the bottom of the scanner.
3. Insert a new cable in the receptacle.
4. Twist to the left to lock the new cable in place.

Connecting to a Host

With some terminal types, the LS 100x is unable to answer host terminal polls until the
appropriate host type is selected. This may result in an error message generated by the host.
To correct this situation, select proper parameter values and initialize the host terminal. See
Chapter 4 for more information.
RS-232C
For external power operation with Synapse "Smart Cable"
1. Plug the Synapse adapter cable into the scanner .
2. Connect the Synapse "Smart Cable" with the host connector.
3. If required, connect the power supply to the input receptacle located on the Synapse
cable.
Figure 1-3. Removing the Cable
Introduction and Setup
1-5