Symbol WSS 1000 Product Reference Manual page 50

h. Select Boot Mode from the main configuration menu. The Boot Mode screen is
displayed.
To change the current boot mode, use the
settings: "Manual entry", "BOOTP", and "DHCP". Refer to
Spectrum24 Network and Flash Disk Utilities
three boot modes.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
i. Select Power Management from the main configuration menu. The Power
Management screen is displayed.
To change the current power management mode, use the
between the settings "PSP" and "CAM". The default setting is "PSP".
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
5. When all of your changes are made, press <CLEAR> to return to the main
configuration menu.
6. Select Exit from the main configuration menu and press <ENTER> to exit the
configurator.
BOOT MODE
IP address from:
Manual entry
ÇÈ,#Clear, Enter
Figure 4-9. Boot Mode Screen
POWER MANAGEMENT
Radio Power Mode
PSP
ÇÈ,#Clear, Enter
Figure 4-10. Power Management Screen
Spectrum24 RF Terminal Setup
ÇÈ#
keys to toggle among the three
for a complete explanation of the
ÇÈ#
Appendix C,
keys to toggle
4-9