Symbol WSS 1000 Product Reference Manual page 46

Table 4-1. Spectrum24 Configuration Parameters (Continued)
Terminal Sleep Mode
Power Management
a. To view the WWC 1040's default parameters, select VIEW CONFIG PARAMS
(Figure 4-2).
This screen is for display only; it is not a data entry screen. Use it to review the
wrist computer's IEEE (or MAC) address, IP address, and Net Id. Press <CLEAR>
or <ENTER> to return to the main menu.
Determines whether radio is powered off after the wrist
computer enters sleep mode due to inactivity. Refer to Appendix
D for more information.
The default value is "On".
If power management is set to PSP, the radio powers up only
when there is traffic on the network. If it is set to CAM, the
radio is always ready to receive. Use the PSP setting to save
battery life.
The default value is "PSP".
VIEW CONFIG PARAMS
Terminal IEEE addr
00:a0:f8:00:02:b8
Terminal IP Address
157.235.93.186
Net Id = 150
ÇÈ, Clear, Enter
Figure 4-2. View Configuration
Parameters Screen
Spectrum24 RF Terminal Setup
4-5