Supercap Power Backup
The wrist computer has a supercap power backup to prevent data loss during battery
replacement. The supercap backup provides sufficient power to preserve memory contents
for approximately 15 minutes while the batteries are replaced.
Note: The supercap does not provide enough power to operate the wrist
computer. Replace or recharge the primary batteries immediately
upon receiving a dead battery message.
Replacing Batteries
To replace the Lithium-Ion battery pack (Symbol p/n 20-16228-02):
1. Power off the wrist computer.
2. Unlock and remove the battery compartment door.
3. Remove the spent battery pack.
4. Insert a fully-charged battery pack in the compartment.
5. Replace and lock the battery compartment cover.
Figure 2-5. Battery Compartment
Cradle Setup
2-7