Table of Contents
Advertisement
WSS 1000 Product Reference Guide
Standard Spectrum24 Software
The WWC 1040 comes with the system software installed, including:
Spectrum24 radio drivers
•
TCP/IP software
•
Configuration files
•
Various utilities.
•
A BIOS of version 1.09 or later is required.
The default files cover most expected installations/initializations with minor changes as
detailed in this chapter.
If your requirements are more advanced, refer to the Spectrum24 Network Development Kit
documentation for more information on the Spectrum24 RF network, SLAODI.COM, the
Symbol-provided ODI driver, and the configuration file setups required for various platforms.
Boot Options & Internet Addressing
Each WWC 1040 requires a unique internet address (IP address), allowing messages it sends
and receives to be correctly routed over networks conforming to the TCP/IP protocol
standards. These addresses can be administered and entered manually, or administered and
allocated by a server on the network.
By default, the WWC 1040 uses NOBOOT (manual entry) to define the IP address. To set
the IP address, use the CFG24 utility described in
Two protocols are defined for the IP address allocation on the network: BOOTP and DHCP.
To allocate IP addresses through BOOTP or DHCP, change the boot option in the
configurator using the Boot Mode parameter.
4-2
Initializing the WWC 1040 on page
4-3.
Advertisement
Table of Contents
Troubleshooting
