Setup And Installation; Tools Required - Eaton Powerware 9125 Installation Manual

INSTALLATION
Table 8. FC 6572 PDM (42R4319)
Quantity Eaton PN
1 103003919-3991
1 164201519
1 103006383
2 152601971-001
4 152601942-001

Setup and Installation

The Powerware 9125 E64 UPS is designed for flexible configurations
and can be installed in a rack, as a standalone cabinet, or in a tower
configuration.
NOTE
to "Installing the Internal Batteries" on page 12. If you are installing the UPS in an IBM
iSeries (0550, 0551, 0554, or 0555 types) or pSeries (7014 type) rack, continue to the
following section, "Tools Required." If you have another type of rack, contact your service
representative (see page 49).
NOTE
the Internal Batteries" on page 12 to begin the UPS setup.

Tools Required

To assemble the components, the following tools may be needed:
S
S
S
4
EATON Powerware
Description
FC 6572 PDM
Powerware 9125 Two-in-One PDM (5000/6000 VA) User's Guide
Accessory Kit
(1) Front Cover (157604790-002)
S
(2) Joining Bracket (157605902-003)
S
(4) Joining Bracket Screws (M4
S
IEC 320-C19 to IEC 320-C20, 16A Equipment Power Cords (4.4m/14 ft)
IEC 320-C13 to C14, 10A Equipment Power Cords (1.8m/6 ft)
For UPS rack installations:
For UPS standalone cabinet or tower installations:
Medium flat-bladed screwdriver
#2 Phillips screwdriver
8 mm wrench or socket
®
9125 (9910-E64) UPS Installation Guide for IBM
×
10 mm) (180500153-306)
If the UPS is pre-installed in an IBM rack, continue
Continue to "Installing
® S
Applications 164201697 Rev 1