Ups Installation - Eaton Powerware 9125 Installation Manual

PDM Input Cord (to UPS)
PDM Output Cord (to UPS)
Input Connector
Neutral-to-Ground
Bonding Screw

UPS Installation

NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur to
your equipment and void your warranty.
To install the UPS:
1.
®
EATON Powerware
Output Receptacle [IEC-309 (P+N+G) 32A]
Figure 20. FC 6572 PDM
If you are installing power management software, connect your
computer to the USB port, UPS communication port, or optional
®
X-Slot card (see Table 18 on page 43). For the communication port,
use only the serial cable supplied in the E64 accessory kit.
USB Port
L6-30 Output Receptacle
L6-30 Input Connector
Figure 21. UPS Rear View
9125 (9910-E64) UPS Installation Guide for IBM
PDM Output
Circuit Breaker
Output Receptacles
(Eight IEC 320-C13)
Output Receptacles (Four IEC 320-C19)
Communication Port
® S
Applications 164201697 Rev 1
INSTALLATION
X-Slot Communication
Bay
REPO Connector
Battery Connector
Battery Circuit
Breaker
21