Eaton Powerware 9125 Installation Manual page 29

2. UPS and FC 6571 PDM: If you are installing a UPS and a PDM and
non-redundant power to the device(s) is desired, plug all the
equipment into the PDM output receptacles (see Figure 32) using
the original device power cords (see Table 11 for IBM plug types
supported). Distribute the load evenly between the rows of
receptacles on the PDM.
NOTE The PDM allows a UPS to be removed for service while providing conditioned power
to the protected device(s).
Table 11. FC 6571 PDM Plug Types Supported
IBM Plug Type
4
5
29
10
12
NOTE If the IBM plug type selected with the equipment to be protected is not
contained in this table, change/order the plug type on the equipment to match the plug
types supported.
UPS and FC 6572 PDM: If you are installing a UPS and a PDM and
non-redundant power to the device(s) is desired, plug all the
equipment into the PDM output receptacles (see Figure 33) using
the power cords located in FC6572 (42R4319); see Table 12 for
IBM plug types supported. Distribute the load evenly between the
rows of receptacles on the PDM.
Table 12. FC 6572 PDM Plug Types Supported
IBM Plug Type
–
–
46
®
EATON Powerware 9125 (9910-E64) UPS Installation Guide for IBM
Description Quantity Supported
NEMA 5-15P
NEMA 6-15P
NEMA 6-20P
NEMA L6-15P
NEMA L6-30P
Description Quantity Supported
IEC 320-C14
IEC 320-C20
IEC-309 (P+N+G) 32A
® S
Applications 164201697 Rev 1
INSTALLATION
2
4 4
2
1
8
4
1
25