Operation; Turning The Ups On; Starting The Ups On Battery - Eaton Powerware 9125 Installation Manual

Hide thumbs Also See for Powerware 9125:

Table of Contents

Chapter 2

EATON Powerware

Operation

This section describes:

Turning the UPS on and off

Starting the UPS on battery

Initiating the battery test

Transferring the UPS to Bypass mode

Operating modes

After the UPS is connected to utility power, it enters Standby mode.

To turn on the UPS, press the On button on the front panel. The

indicator illuminates solid and the bar graph indicators display the

percentage of load being applied to the UPS.

NOTE Before using this feature, the UPS must have been powered by utility power at least

once.

To turn on the UPS without using utility power, press and hold the

On button for approximately three seconds. The UPS supplies power

to your equipment and transfers to Battery mode.

9125 (9910-E64) UPS Installation Guide for IBM

Applications

164201697 Rev 1

Table of Contents

9910-e64