Table of Contents
Advertisement
The system responds with:
To change the SFS 7012 default IP address enter:
Step 6
where -h ipaddress is the new IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format, and -m
netMask is the new subnet mask in dotted decimal (i.e., xxx.xxx.xxx.xxx) format.
Note
To change the SFS 7012 default gateway IP address enter:
Step 7
where -h ipaddress is the new default gateway IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx)
format.
Step 8
To to exit the CLI enter:
Using the Chassis Viewer GUI
Power up the switch.
Step 1
Connect a Category 5 or 6 (Cat 5/6) Ethernet cable to the RJ-45 connector on spine 1. Connect the other
Step 2
end of the Cat 5/6 to an OOB LAN Ethernet hub or Ethernet switch where a work station can access the
7012. A work station can be connected directly to the Ethernet port of spine 1 of the 7012 if using a
crossover Ethernet cable. Power up the switch.
To start Chassis Viewer, open a web browser and enter the default IP of the switch (i.e., 192.168.100.9).
Step 3
Note
Note
Note
If web authentication is enabled, the following screen will be displayed:
Step 4
Note
OL-8787-05
super
Welcome to the SFS 7012 CLI. Type 'list' for the list of commands.
setChassisIpAddr -h ipaddress -m netMask
After changing the IP address the chassis TELNET/SSH session is terminated and must be
reopened using the new IP address.
setDefaultRoute -h ipaddress
logout
The browser must be on a workstation connected to the same Ethernet LAN, and on the same
TCP/IP subnet as the switch RJ-45 OOB LAN port.
Chassis Viewer supports the following browsers: Microsoft Internet Explorer 6.0+ and Mozilla
version 1.6.x+
If the user is leaving their workstation for a period of time, be sure to close the browser window.
If web authentication is not enabled, skip to Step 5.
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
1-23
Advertisement
Table of Contents
