Chapter 5. Network Configuration
Remote Configuration
1= LOCAL
3= CONFIG
2= REMOTE ENTER
1=DISABLE
2=ENABLE
5-4
This option sets up the DSU III AR to accept or reject remote
configuration commands. Figure 5-3 shows the menu path for
enabling/disabling remote configuration. The factory
default setting is E
1= NETWORK OPT.
2= DTE OPTIONS
3= TEST OPTIONS
ADDRESS
4= DIAL OPTIONS
5= MANUAL COMMAND
Figure 5-3. Enabling/Disabling Remote Configuration
Table 5-3 shows the equivalent AT commands used to enable or
disable remote configuration.
Table 5-3. Remote Configuration Commands
Front Panel
AT Command
&P4
&P5
DSU III AR User Manual
.
NABLED
1= LOOP RATE
2= NETWORK ADDR
3= REMOTE CONFIG
4= NETWORK TYPE
5= CLOCK SOURCE
Description
Disable Remote Configuration
Enable Remote Configuration
1= DISABLED
2= ENABLED
61202011L1-1