Anti-Stream; Figure 6-8. Anti-Stream Options; Table 6-7. Anti-Stream At Commands - ADTRAN DSU III AR User Manual

Chapter 6. Configuring DTE Options

Anti-Stream

The A
The anti-stream time-out is the maximum time the DSU III AR
transmits data into the network from the DTE. This feature
prevents one DTE device on a multi-drop network from
continuously tying up the transmit circuit back to the master DSU.
Figure 6-8 shows the menu path used to access the A
options menu.
The anti-stream timer is reset to zero when RS changes to the active
state and is updated every second while RS is active. When the
anti-stream time-out expires, the DSU III AR stops transmitting
DTE data into the network but continues to accept data from it.
This condition exists until the DTE deactivates the RS input.
1= LOCAL
3= CONFIG
2= REMOTE ENTER
The factory default setting is T
available options and their AT commands.
6-12
-S option is used to select the anti-stream time-out.
NTI TREAM
1= NETWORK OPT
2= DTE OPTIONS
3= TEST OPTIONS
ADDRESS 4= DIAL OPTIONS
5= MANUAL COM.
Front Panel AT Command Description
1=TIMER OFF %T0
2=TIME 10 SEC. %T1
3=TIME 30 SEC. %T2
4=TIME 60 SEC. %T3
DSU III AR User Manual
1= DTE RATE
2= CONNECTOR TYPE
3= DATA FORMAT
4= DTE CMD OPTION
5= TRANSMIT CLOCK
6= CS OPTIONS
7= ANTI-STREAM
8= CD OPTIONS
9= TR OPTIONS
A= SR OPTIONS
B= AUXILIARY PORT

Figure 6-8. Anti-Stream Options

O . Table 6-7 shows the
IMER FF

Table 6-7. Anti-Stream AT Commands

Anti-stream timer disabled
Time-out equal 10 seconds
Time-out equal 30 seconds
Time-out equal 60 seconds
-S
NTI TREAM
1= TIMER OFF
2= TIME 10 SEC.
3= TIME 30 SEC.
4= TIME 60 SEC.
61202011L1-1