Configuration Methods; Table 4-1. Configuration Methods - ADTRAN DSU III AR User Manual

Chapter 4. Configuration Overview
additional configuration is required to put the unit into service. If
profile 1 does not match system requirements, it can be modified,
or one of the other profiles that more closely matches the system
requirements can be loaded into current memory. When a different
profile is loaded, or the existing profile is modified, it is stored in
the current (nonvolatile configuration) memory. The DSU III AR is
then configured with that profile every time power is turned on or
until the unit is reset.
For detailed information on configuration see Chapter 5, Network
Configuration on page 5-1, Chapter 6, Configuring DTE Options on
page 6-1, Chapter 7, Configuring Test Options on page 7-1, Chapter 8,
Configuring Dial Options on page 8-1, and Chapter 9, Manual
Command on page 9-1.

Configuration Methods

The DSU III AR responds to the following methods of
configuration:
•
•
•
•
•
The DSU III AR provides methods for both local and remote
configuration. These methods are shown in Table 4-1.
4-2
VT-100 Compatible Terminal
AT Commands
V.25 Commands
Front Panel Commands
Remote Commands from another DSU running SLIP/PPP
protocol.
Method
AT Commands
V.25 Commands
Front Panel
DATAMATE
VT-100
DSU III AR User Manual

Table 4-1. Configuration Methods

Stand Alone
Local Remote
Yes Yes
Yes Yes
Yes Yes
No Yes
Yes Yes
61202011L1-1