Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
32
202480-11
Assemblin the fork le s
Info
When assembling, ensure that the right cartridge is mounted in the corresponding inner tube and the
right adjuster is mounted on the corresponding screw cap.
Compression damping side - screw cap with mark
Rebound damping side - screw cap with mark
e
/
-8
"
- 8
201714-10
@)
-
Clamp piston rod
with the special tool.
I Clamping stand (T14049S)
-
Mount spring guide � all the way on.
Info
The nut must be firmly tightened against the stop by
hand. Do not use a tool.
G,.
-
Mount adjusting tube
-
Unclamp the piston rod. Mount the preload spacer(s).
brake caliper holder, white adjuster.
COMP,
no brake caliper holder, red adjuster.
REB,
Preparatory work
-
Assemble the hydrostop unit.
Main work
-
Clamp the inner tube with the axle clamp.
Guideline
I Use soft jaws.
-
Mount the special tool.
I Protecting sleeve (T1401)
-
Grease and push on dust boot
I Lubricant (T14034)
(0
p. 308)
Info
Always change the dust boot, seal ring, lock ring, and
support ring.
Mount the sealing lip with the spring expander facing
down.
8 .
-
Push on lock ring
-
Grease and push on seal ring (D.
I Lubricant (T14034)
(I!!,!
p. 308)
•
Info
I
Sealing lip downward, open side upward.
8.
-
Push on support ring
-
Remove the special tool.
(I!!,!
p. 325)
(I!!,!
p. 28)
(�
p. 324)
O .
Advertisement
Table of Contents
