Installing The Oil Pressure Regulator Valve; Removing The Crankshaft Seal Ring In The Clutch Cover; Installing The Crankshaft Seal Ring In The Clutch Cover; Removing The Water Pump - Husqvarna FE 450 2014 Repair Manual

18 ENGINE
18.4.5
e "
•-·
18.4.6
18.4.7
18.4.8
180

Installing the oil pressure regulator valve

�-­
.. - •
"-:)
"-
304671-11

Removing the crankshaft seal ring in the clutch cover

309242-10

Installing the crankshaft seal ring in the clutch cover

309242-10

Removing the water pump

309243-10
O
Install ball and pressure spring
-
Mount and tighten plug@} with sealing washer
Guideline
Oil pressure control
valve plug
-
Remove the crankshaft seal ring in clutch cover
-
Press crankshaft seal ring
open side flush toward the inside.
-
Grease the sealing lip.
O.
-
Remove nut
-
Remove water pump impeller@.
Info
If the water pump impeller cannot be detached, then
the water pump shaft can be pressed out toward the
inside.
8.
C,.
M12x1.5 20 Nm (14.8 lbf ft)
O.
O
into the clutch cover with the