Mitsubishi Electric MR-J5D-G-N1 User Manual page 84

7.8
Positioning extension setting servo parameters
group ([Pr. PV_ _ ])
[Pr. PV23_Speed unit conversion - Electronic gear - Numerator
(*VCMX)]
Initial value
1
Set the electric gear numerator for converting the speed (command unit/s) into a value in speed units.
This function is enabled when [Pr. PT01.1 Speed/acceleration/deceleration unit selection] is set to "1".
[Pr. PV24_Speed unit conversion - Electronic gear - Denominator
(*VCDV)]
Initial value
1
Set the electric gear denominator for converting the speed command (command unit/s) into a value in speed units.
This function is enabled when [Pr. PT01.1 Speed/acceleration/deceleration unit selection] is set to "1".
[Pr. PV25_Acceleration unit conversion - Electronic gear -
Numerator (*ACMX)]
Initial value
1
Set the electric gear numerator for converting the acceleration (command unit/s
units.
This function is enabled when [Pr. PT01.1 Speed/acceleration/deceleration unit selection] is set to "1".
[Pr. PV26_Acceleration unit conversion - Electronic gear -
Denominator (*ACDV)]
Initial value
1
Set the electric gear denominator for converting the acceleration (command unit/s
units.
This function is enabled when [Pr. PT01.1 Speed/acceleration/deceleration unit selection] is set to "1".
[Pr. PV33_For manufacturer setting]
This servo parameter is for manufacturer setting.
7 SERVO PARAMETERS
82
7.8 Positioning extension setting servo parameters group ([Pr. PV_ _ ])
Setting range
1 to 1024
Setting range
1 to 256
Setting range
1 to 1024
Setting range
1 to 256
Setting method
Each axis
Setting method
Each axis
Setting method
Each axis
2
) into a value in acceleration/deceleration
Setting method
Each axis
2
) into a value in acceleration/deceleration
Ver.
A5
Ver.
A5
Ver.
A5
Ver.
A5