Table of Contents
Advertisement
14 WHEELS
101
Remove spacers
©
M
hd
<=>[
©
©
M
H00934-10
14.7.2
Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
-
Always keep the brake discs free of oil and grease.
-
Clean the brake discs with brake cleaner when necessary.
A
m
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
- Change the front wheel bearing. (E8 p. 103)
Clean and grease shaft seal rings O and mating surfaces
©
of the spacers.
' , v-
(p; O
05PO
-
'
.
I
©
©
Long-life grease (id p. 318)
&.=r>(
<3=^
Insert the spacers.
M
H00935-10
T.
I
Lift the front wheel into the fork, position it, and insert the wheel spindle.
S The brake linings are correctly positioned.
Mount and tighten screw
©
Guideline
%
I VIA
■
M
Screw, front wheel spindle
M24x1.5
45 Nm (33.2 Ibf ft)
/©
wm
Operate the hand brake lever several times until the brake linings are seated cor
rectly against the brake disc.
Remove the motorcycle from the lift stand. (Si p. 12)
Operate the front brake and compress the fork a few times firmly.
S The fork legs straighten.
Tighten screws
©
Guideline
j'
w
YEz
S01058-11
1
Screw, fork stub
M8
15 Nm (11.1 Ibf ft)
14.7.3
Removing the front wheel using work stand
Preparatory work
-
Raise the motorcycle with the work stand, (ii p. 12)
-
Place a load on rear of vehicle.
The front wheel is not in contact with the ground.
Main work
-
Press the brake caliper onto the brake disc by hand in order to push back the
brake pistons.
Info
Make sure that you do not press the brake caliper against the spokes
when pushing back the brake pistons.
r
9
I
&
D00919-10
Advertisement
Table of Contents
