HP Vectra VE4 User Manual page 54

Installing or Replacing an IDE Hard Disk Drive in the Rear Shelf
Refer to the drive's manuals to see if you must set jumpers or if there is a special installation
procedure to follow.
Create a bootable diskette before replacing the installed IDE drive.
Use the Master Diskette Creation utility to create a bootable master copy of the operating
system. This utility is located in the HPutils group.
For non-DOS/Windows operating systems, refer to the operating system documentation for
information on creating a bootable diskette, formatting a drive, and installing the operating
system.
1. Disconnect the computer's power supply cable.
2. Remove the computer's cover (see "Removing and Replac ing the Cover").
3. Place the drive—with its label uppermost—on the frame above the disk drives.
4. Align the drive with the hinges on the rear drive shelf. Then insert it into the hinges.
5. Rotate the drive on its hinges. Secure it using the screw provided.
Vectra VE 4/xx User's Guide 3 Installing Accessories In Your PC 54