Completing The Installation Of A Drive - HP PL Class 450/500/550/600/650/700/750 User Manual

When an IDE CD-
ROM Drive Is
Installed
When a Flexible
Disk Drive Is
Installed
How to Install Accessories In Your HP Visualize Linux Workstation
Installing Mass Storage Devices
Slide the power supply back into position, and tighten the four self-
retaining screws (see page 26).
Remove the plastic panel from the cover by pulling the panel from the
left and unhinging its right-hand side. Store the panel in a safe place.
Install any other accessories before replacing the cover and completing
the installation.

Completing the Installation of a Drive

1. Switch on the computer and press
2. In the Setup program, select the Advanced menu, the IDE Devices
submenu. Check that the CD-ROM drive has been detected on the
IDE channel.
3. Press to save and exit the program.
1. Switch on the computer and press
2. In the Setup program, select the Advanced menu, the Flexible Disk
Drives submenu, and check that the drive has been detected.
3. Press to save and exit the program.
46
Unclip and lift out
the plastic panel
when Setup appears.
when Setup appears.
Chapter 2