Configuring Your Network Connection - HP PL Class 450/500/550/600/650/700/750 User Manual

Technical Information
Configuring Your Network Connection
Configuring Your Network Connection
Use the information in this section if your HP V
Workstation comes with an HP-supplied integrated network solution.
You must use the Workstation's Setup program (described on in the
section "The HP Summary Screen and Setup Program") to change the
integrated Ethernet interface settings. The following table summarizes
which network options you can set using the Setup program.
Network Setup Items
Enable the integrated network interface.
Enable your Workstation to be started
(booted and logged on) from the
network.
Enable remote power-on of your
Workstation.
From "Suspend Wakeup" mode, enable
your Workstation to return to full power
when a command is received by the
integrated network interface.
Determine boot device priority.
1. Disabling the LAN card will only disable certain features of the LAN
card, such as remote power-on or remote wakeup, not the card itself.
96
Where to find in Setup
1 In the Advanced menu, go to the
Integrated Network Interface
submenu.
In the Security menu, go to the Boot
Devices Security submenu
(described below).
In the Power menu, enable the
Integrated Network item.
In the Power menu, enable the
Integrated Network item.
In the Boot menu, select the Boot
Device Priority list item (described
on the next page).
Linux
ISUALIZE
Chapter 4