HP PL Class 450/500/550/600/650/700/750 User Manual page 77

c. Turn on the Workstation. This will erase the CMOS memory.
d. Wait until the Workstation has started. A message will be
displayed similar to this: "Configuration has been cleared, set
switch Clear CMOS to the open position before rebooting."
e. Turn off the Workstation, disconnect the power cable, and remove
the cover.
f. Set the system board switch 6 (CLEAR CMOS) UP to retain the
configuration.
2. Replace the cover, and reconnect the power and cables.
3. Switch on the Workstation. An error message will be displayed
similar to the following:
On your monitor:
Incorrect Configuration
The Workstation will stop. Press
and then press
4. Run Setup by pressing
automatically downloaded and saved.
5. Make any other changes you want and press
configuration and exit from Setup.
Chapter 3
Troubleshooting Your HP Visualize Linux Workstation
If Your Workstation Does Not Start Properly
On your Workstation's LCD:
Error! POST 0012
.
. CMOS default values will be
(to view the system errors)
to save the
61