Connecting An External Scsi Accessory - HP PL Class 450/500/550/600/650/700/750 User Manual

NOTE
Setting Up and Using Your HP Visualize Linux Workstation

Connecting an External SCSI Accessory

Your HP V
ISUALIZE
16-bit SCSI connector for external SCSI devices.
When an external SCSI device is connected, the UltraWide 16-bit SCSI
controller automatically switches to non-Ultra mode (maximum capacity
of 20 MBs per second).
An external SCSI device is connected as follows:
1. You should assign an unused SCSI address to the accessory. SCSI
addresses range from 0 to 15 for wide 16-bit SCSI. The SCSI
address 0 is reserved for the first SCSI hard disk drive and SCSI
address 7 is reserved for SCSI controller (the default for narrow and
wide SCSI devices).
Refer to the manual provided with the SCSI accessory for
instructions on selecting a SCSI address.
You don't need to set a SCSI address for Plug and Play SCSI devices
(SCSI devices which support the SCAM protocol).
2. Make sure the SCSI accessory is terminated correctly—either
internally or by a terminating resistor (refer to the manual provided
with the SCSI accessory).
Chapter 1
Connecting an External SCSI Accessory
Linux Workstation is equipped with an UltraWide
Make sure the SCSI
accessory is terminated
7