System Specifications; Power Consumption Information; Maximum Loads Available For Accessory Slots; Irqs, Dmas, And I/O Addresses - HP PL Class 450/500/550/600/650/700/750 User Manual

NOTE
Technical Information
System Specifications
System Specifications

Power Consumption Information

Maximum power consumption
Typical consumption with:
• One processor installed
• Two processors installed
Off
Note that the power supply in your HP V
continues to supply power to the CMOS memory, even when switched off.
When the Workstation is turned off with the power button on the front
panel, the power consumption falls below 5 Watts, but is not zero. The
special on/off method used by this Workstation considerably extends the
lifetime of the power supply. To reach zero power consumption in "off "
mode, either unplug the Workstation from the power outlet or use a
power block with a switch. You should be aware that, in this case, the
Workstation will lose its time settings within a few days.

Maximum Loads Available for Accessory Slots

The load limits for the ISA and PCI accessory slots are compliant with
ISA and PCI specifications. More details of permitted loads are provided
on the World Wide Web (refer to the section "HP World Wide Web Site" in
the chapter "Hewlett-Packard Support and Information Services" for
access details) in the support documentation section for your
Workstation.

IRQs, DMAs, and I/O Addresses

The IRQ, DMA, and I/O address mappings shown here are for a basic
80
200 W
approx. 99 W
approx. 85 W
2.5 W
Linux Workstation
ISUALIZE
Chapter 4