Resistance Does Not Respond - Bowflex Max Total 16/40 Service Manual

Resistance Does Not Respond

BEGIN HERE
Remove the right side
lower round cover.
Replace the Mast
Harness Cable
Does the resistance
respond now?
YES
Issue resolved.
Is the red light
around the
NO
Resistance Knob
lit?
YES
YES
Does the fan turn
Plug the power cord back in, and power up the display. If the inlet wire
was unplugged, plug it back in.
Begin any workout using the
console. Turn the Resistance
NO
Knob up and see if the Servo
Motor and Brake Arm move.
Did they move?
Replace the Servo
Motor.
NO
Remove console from console mast.
Unplug I/O cables and inspect for damage. Reconnect cables.
Each Cable connector (3-pin, 4-pin, 5-pin and 12-pin) has a
corresponding end connector with that many openings. Be
sure to orient the cables properly (as shown), and to fully connect
the cable connectors.
Plug the cable in.
NO ing: Machine Seized
freely?
Reattach / adjust the
tension cable
Replace the brake
assembly.
14
a cable already
YES
unplugged?
Go to Troubleshoot-
Up
If stll not working,
replace the Static
Handlebar Assembly
Visually inspect the
motor. Check to make
sure that the metal cable
YES
is properly attached to
the motor and the brake
arm.
Has the
metal tension cable
YES
come off track, or need
adjustment?
NO
Is the red, magnetic
YES
brake arm broken?
NO
Is the metal tension
cable broken?
Replace the cable.
Was
NO