Bowflex Max Total 16/40 Service Manual page 142

5. Using a #2 Phillips screwdriver, remove the indicated (by ovals)
screws and only loosen the lowest indicated screw (arrow) from the
Right Fan Cover.
Note: Loosen the lowest screw by at least 3 full rotations.
6. The Right Fan Cover has a tab that needs to be pushed upward to
clear the loosened screw. While pushing up on the tab, remove the
Right Fan Cover from the assembly.
Note: The Power Cable is attached to the inside of the Right Fan
Cover. Be sure not to crimp the cable by placing the Right Fan Cover
close to the front of the machine.
To assist with assembly, note that the upper screw is a machine
screw and not a self-tapping screw.
Power Inlet
Power Cable
7. Remove the indicated Cap from the machine.
Cap
Leg Assembly
8. Using a 6mm hex wrench, remove the hardware exposed below
the Cap from the machine.
9. Slide the Right Leg Assembly off of the machine.
142