Bowflex Max Total 16/40 Service Manual page 64

5. Using a #2 Phillips screwdriver, remove the indicated (by ovals)
screws and only loosen the lowest indicated screw (arrow) from the
Right Fan Cover.
6. The Right Fan Cover has a tab that needs to be pushed upward to
clear the loosened screw. While pushing up on the tab, remove the
Right Fan Cover from the assembly.
Note: The Power Cable is attached to the inside of the Right Fan
Cover. Be sure not to crimp the cable by placing the Right Fan Cover
close to the front of the machine.
To assist with assembly, note that the upper screw is a machine
screw and not a self-tapping screw.
Power Inlet
Power Cable
7. Remove the indicated Cap from the left side of the machine.
8. Using a 6mm hex wrench, remove the hardware exposed from
below the Cap.
9. Lift the Foot Pedal and slide the Leg Assembly straight off the
machine. Be sure to pull straight out, or the Leg Assembly may be
difficult to remove.
Note: A rubber mallet may be necessary if the Leg Assembly will not
Cap
slide off.
Leg Assembly
Foot Pedal
10. Remove the Wave Washer from the Crank Arm, and place it in a
secure location for re-use.
64