Bowflex Max Total 16/40 Service Manual page 72

24. Using a #2 Phillips screwdriver, remove the screws from the Left
Shroud. ( 9 screws on the Left Shroud) Remove the upper screws
labeled ' * ' last.
25. Using a 4mm hex wrench, remove the screw indicated by "A" from the
Drive Belt Tensioner Arm.
26. Using a 10mm wrench, remove the securing nuts (if present) from the
back side of the Drive Pulley.
27. Using a 8mm hex wrench, loosen the screw indicated by "B" until the
Drive Belt is free enough to be removed from the Drive Pulley. Remove
the Drive Belt.
Keep fingers out of any pinch opportunities when removing
the Fan Belt.
28. Using a 5mm hex wrench, remove the four screws that attach the
Drive Pulley. Be sure to support the weight of the Drive Pulley when
removing hardware because it will fall.
29. Using a 5mm hex wrench, attach the new Drive Pulley to the Frame
Assembly.
30. Replace the Drive Belt around the new Drive Pulley.
31. Replace and tighten the "A" screw on the Drive Belt Tensioner Arm,
and then tighten the "B" screw.
*
Right Side
Drive Pulley
Drive Belt
72
*
Left Side
Drive Belt
Tensioner Arm
A
B