Bowflex Max Total 16/40 Service Manual page 70

10. Using a #2 Phillips screwdriver, remove the indicated screw from the
Rear Shroud.
11. Carefully remove the Rear Shroud from the machine. Place a standard
screwdriver behind and near the middle of the Rear Shroud and gently pry
until it releases. Then move the screwdriver to the bottom and gently pry
until the Rear Shroud comes off.
Rear Shroud
12. Using a #2 Phillips screwdriver, remove the indicated (by oval) screw
and only loosen the lowest indicated screw (arrow) from the Left Fan
Cover.
13. The Left Fan Cover Assembly has a tab that needs to be pushed
upward to clear the loosened screw. While pushing up on the tab, remove
the Left Fan Cover Assembly.
14. Remove the Left Fan Cover Assembly from the machine. Be sure to
note how the fan screens are set into the Left Fan Cover to assist with the
replacement procedure.
15. Using a #2 Phillips screwdriver, remove the 2 indicated screws from
the Left Crank Cover.
Pivot Arm
16. Remove the Left Crank Cover from the machine.
17. Place a rag or protective material below the Left Connector Arm to
protect the Shroud from potential scratches from the Connector Arm.
18. Using a 6mm hex wrench, remove the hardware that connects the Left
Crank Cover
Connector Arm
Connector Arm and the Pivot Arm.
Note: The Connector Arm will pivot downward if not lowered slowly onto
the rag protecting the Shroud.
70