Panasonic KX-FM330GR Service Manual page 96

KX-FP320G / KX-FM330G
(1) CODE
59 COMMUNICATION ERROR
(Komm. Fehler)
59 COMMUNICATION ERROR
(Komm. Fehler)
64 COMMUNICATION ERROR
(Komm. Fehler)
65 COMMUNICATION ERROR
(Komm. Fehler)
68 COMMUNICATION ERROR
(Komm. Fehler)
70 COMMUNICATION ERROR
(Komm. Fehler)
72 COMMUNICATION ERROR
(Komm. Fehler)
73 COMMUNICATION ERROR
(Komm. Fehler)
74 JUNKMAIL PROH. REJECT
(Empfang abgelehnt)
75 MEMORY FULL (Speicher
voll)
79 CANCELED (ANNULLIERT)
FF COMMUNICATION ERROR
(Komm. Fehler)
TX(SENDEN)=TRANSMISSION RX(EMPF)=RECEPTION
Most fax communication problems can be resolved by the following steps.
a. Change the transmit level. (Service code: 596, refer to 2.4.4. SERVICE FUNCTION TABLE.)
b. Change the TX(SENDEN) speed/RX(EMPF) speed. (Service code: 717/718, refer to 2.4.4. SERVICE FUNCTION TABLE.)
If not resolved, see the Countermeasure flow chart.
Note:
Words in brackets ( ) are German. A translated version for each market is available with this model serise.
(2) RESULT (3) MODE
TX(SENDEN) DCN responds to post message.
TX(SENDEN) DCN responds to post message.
TX(SENDEN) Polling is not possible.
TX(SENDEN)
RX(EMPF)
RX(EMPF)
RX(EMPF)
TX(SENDEN) &
RX(EMPF)
RX(EMPF)
RX(EMPF)
TX(SENDEN) The multistation transmission is rejected by user.
TX(SENDEN) &
RX(EMPF)
SYMPTOM
No response at the other party after MCF or CFR is
transmitted.
DCN is received after CFR transmission.
Carrier is cut when image signal is received.
300BPS error.
Junk Mail Prohibitor ID ???
The document was not received due to memory full.
Modem error. For the DCN, DCS and other
addreviations, refore to 6.6.MODEM SECTION.
54
Counter-
measure*
14
14
15
13
13
16
12