Panasonic KX-FM330GR Service Manual page 95

7. How to output the Journal Report:
a. Press the MENU button 3 times.
b. Press the START/SET button and VOLUME( ) button 3 times.
c. Press the START/SET button.
d. Print out.
Sample of transmission report
Error code table:
(1) CODE (2) RESULT
A2 PRESSED THE STOP KEY
(Stop-Taste gedückt)
A3 DOCUMENT JAMMED
(Fehleinzug)
A4 NO DOCUMENT (Kein
Dokument)
A7 THE COVER WAS OPENED
(Deckl offen)
A9 COMMUNICATION ERROR
(Komm. Fehler)
26 COMMUNICATION ERROR
(Komm. Fehler)
27 COMMUNICATION ERROR
(Komm. Fehler)
28 COMMUNICATION ERROR
(Komm. Fehler)
40 NO RESPONSE (Keine
Antwort)
41 COMMUNICATION ERROR
(Komm. Fehler)
42 COMMUNICATION ERROR
(Komm. Fehler)
43 COMMUNICATION ERROR
(Komm. Fehler)
44 COMMUNICATION ERROR
(Komm. Fehler)
46 COMMUNICATION ERROR
(Komm. Fehler)
48 COMMUNICATION ERROR
(Komm. Fehler)
49 COMMUNICATION ERROR
(Komm. Fehler)
50 COMMUNICATION ERROR
(Komm. Fehler)
51 COMMUNICATION ERROR
(Komm. Fehler)
52 NO RESPONSE (Keine
Antwort)
53 COMMUNICATION ERROR
(Komm. Fehler)
54 COMMUNICATION ERROR
(Komm. Fehler)
57 COMMUNICATION ERROR
(Komm. Fehler)
58 COMMUNICATION ERROR
(Komm. Fehler)
(3) MODE
TX(SENDEN) & Communication was interrupted with the STOP button.
RX(EMPF)
TX(SENDEN) Document paper is jammed.
TX(SENDEN) No document paper.
TX(SENDEN) & Cover is open.
RX(EMPF)
TX(SENDEN) & DC LOOP detection/Busy Tone detection.
RX(EMPF)
RX(EMPF) DIS is received after transmission.
RX(EMPF)
TX(SENDEN) &
RX(EMPF)
TX(SENDEN) Transmission is finished when T1 TIMER is expired.
TX(SENDEN) DCN is received after DCS transmission.
TX(SENDEN) FTT is received after transmission of a 2400BSP
training signal.
TX(SENDEN) No response after post message is transmitted three
times.
TX(SENDEN) RTN and PIN are received.
RX(EMPF) No response after FTT is transmitted.
RX(EMPF) No post message.
RX(EMPF) RTN is transmitted.
RX(EMPF) PIN is transmitted (to PRI-Q).
RX(EMPF) PIN is transmitted.
RX(EMPF) Reception is finished when the T1 TIMER expired.
TX(SENDEN) DCN is received after transmission of NSC and DTC.
RX(EMPF) DCN is received after DIS transmission.
TX(SENDEN) 300BPS error.
RX(EMPF) DCN is received after FTT transmission.
53
SYMPTOM
KX-FP320G / KX-FM330G
Counter-
measure*
1
2
3
4
5
6
7
8
8
8
9
10
11
12
13