Panasonic KX-FM330GR Service Manual page 154

KX-FP320G / KX-FM330G
Note:
The numbers in boxes (XXX) indicate the keys to be input for the various test modes.
2.5.1. DTMF SIGNAL TONE TRANSMIT SELECT
When set to ON (=1), the 12 keys and transmission
frequencies are as shown.
key High Frequency (Hz)
"1"
"2"
"3"
"4"
Note:
After performing this check, do not fail to turn the setting off. Otherwise, it will not be possible to dial using DTMF.
2.5.2. BUTTON CODE TABLE
Note:
These codes (00, 01) are only for the data in the History Report.
Test mode
Type of Mode
SENSOR
Service Mode
CHECK & VOX
CHECK
Key Low Frequency (Hz)
697 "5" 1209
770 "6" 1336
852 "7" 1477
941
• Code
Function
• Operation after
code input.
After entering this mode, by operating the sensor levers, etc.
8 1 5
Useing your hands, each sensor and SW display above the
LCD will go ON/OFF.
START
For each sensor's thermal head operation, refer to 6.5. SEN-
SOR AND SWITCHES.
LCD display
Do Sn Co Pf Pl Pt Ri Vx
Do: Document set sensor: Paper inserted. Do turns on when a document is inserted.
Sn: Read position sensor: At the read position. Sn turns on when the front cover is
opened and the sensor lever is pressed directly.
Co: Cover open sensor: Cover open. Co turns on and off when the front cover is
opened and closed.
Pf: Paper full sensor: Sensor on. Pf turns on when the sensor lever is pressed di-
rectly via the lower cabinet jam release window.
Pl: Paper set switch: Sensor on. Pl turns on and off when the cassette lock lever
is pushed down and up.
Pt: Paper top sensor: Sensor on. Pt turns on when the front cover is opened and
the sensor lever is pressed directly.
Ri: Film and sensor: Sensor on. Ri turns on and off when the film end sensor
gear is turned.
Detection signal for the tone on the line. Turns on when
Vx: Vox signal:
there is a tone signal on the line.
When set to OFF (=2), the 12 keys and transmission
frequencies are as shown.
High (Hz)
Low (Hz)
697
770
852
941
112
1209
1336 1477
"2" "3"
"1"
"5" "6"
"4"
"8" "9"
"7"
"0"
"#"