Panasonic KX-FM330GR Service Manual page 162

KX-FP320G / KX-FM330G
3.3.2. ADJUSTMENT
WHITE LEVEL ADJUSTMENT
1. Remove the CCD TOOL from CCD unit.
2. Attach the white paper on the CCD unit.
3. Attach the CCD TOOL on the CCD unit.
4. Adjust VR801 on the CCD board so that the waveform becomes 1.2± 0.2V.
Note:
1. After the adjustment is finished, assemble the unit by reversing above procedure.
2. While making adjustments, cover the top of the lens with something (such as a thick piece of paper) to prevent light from
entering.
3. If you have no instrument to repair, trim off the chart on next page, then attach on the target glass.
(This is a temporary treatment. You should use CCD Tool for this time adjustment purpose, if you require an accurate
repairment.)
120