Panasonic KX-FM330GR Service Manual page 65

1.15.2.1. MAINTENANCE LIST
NO. OPERATION
1 Document Path
2 Rollers
3 Platen Roller
4 Thermal Head
5 Target Glass, White
Plate
6 Sensors
7 Mirrors and Lens
8 Abnormal, wear and tear
or looseness parts
1.15.2.2. MAINTENANCE CYCLE
No. Item
1 Separation Roller (Ref. No. 165)
2 Separation Rubber (Ref. No. 57)
3 Feed Rollers (Ref. No. 135, 139)
4 Target Glass, White Plate (Ref.
No. 201, 54)
5 Thermal Head (Ref. No. 67)
6 Platen Roller (Ref. No. 133)
7 Pickup Roller (Ref. No. 142)
* These values are standard and may vary depending on usage conditions.
Remove any foreign matter such as paper.
If the roller is dirty, clean it with a damp cloth then dry thoroughly.
If the platen is dirty, clean it with a damp cloth then dry
thoroughly.Remove the paper and film cartridge before cleaning.
If the thermal head is dirty, clean the printing surface with a cloth
moistened with denatured alcohol (alcohol without water), then dry
thoroughly.
If the Target glass and white plate are dirty, clean the glass with a soft dry
cloth.
Document sensor (PI302), Read position sensor (PI301), Hook switch
(SW401), Paper top sensor (PI402), Paper full sensor (PI401), Film end
sensor (PI403), Cover open sensor (PI303) and Paper set switch (SW3).
Confirm operation of sensors.
If the mirror and lens are dirty, clean them with a soft dry cloth.
Exchange the part.Check the tightness of screws on all parts.
Cleaning
Cycle Procedure
3 months See 1.15.3.
MAINTENANCE.
3 months See 1.15.3.
MAINTENANCE.
3 months See 1.15.3.
MAINTENANCE.
3 months See 1.15.3.
MAINTENANCE.
3 months See 1.15.3.
MAINTENANCE.
3 months See 4. DISASSEMBLY
INSTRUCTIONS.
3 months See 4. DISASSEMBLY
INSTRUCTIONS.
CHECK
Cycle
7 years*
(100,000 documents)
7 years (100,000 documents) See 4. DISASSEMBLY
7 years (100,000 documents) See 4. DISASSEMBLY
7 years (100,000 documents) See 4. DISASSEMBLY
7 years (100,000 documents) See 4. DISASSEMBLY
7 years (100,000 documents) See 4. DISASSEMBLY
7 years (100,000 documents) See 4. DISASSEMBLY
23
KX-FP320G / KX-FM330G
REMARKS
—
See 1.15.3. MAINTENANCE.
—
See 1.15.3. MAINTENANCE
and 4. DISASSEMBLY
INSTRUCTIONS.
See 1.15.3. MAINTENANCE.
See 1.15.2. MAINTENANCE
CHECK ITEMS/COMPONENT
LOCATIONS or 2.3.3.9.
Sensor Board Section and
6.5. SENSORS AND
SWITCHES.
—
—
Replacement
Procedure
See 4. DISASSEMBLY
INSTRUCTIONS.
INSTRUCTIONS.
INSTRUCTIONS.
INSTRUCTIONS.
INSTRUCTIONS.
INSTRUCTIONS.
INSTRUCTIONS.