Panasonic KX-FM330GR Service Manual page 69

DISPLAY MESSAGE
NO FAX REPLY
( K e i n e F a x a n t w . )
PAPER JAMMED
( P a p i e r s t a u )
PLEASE WAIT
( B i t t e w a r t e n )
POLLING ERROR
( A b r u f F e h l e r )
REDIAL TIME OUT
( W W Z e i t a b l a u f )
REMOVE DOCUMENT
( S t a u b e s e i t i g e n )
TRANSMIT ERROR
( E m p f . F e h l e r )
UNIT OVERHEATED
( T h e r m o k o p f h e i ß )
MWSSAGE FULL
( S p r a c h s p . v o l l )
NO TAD GREETING
( K e i n e A n s a g e )
KX-FM330 only
PC FAIL OR BUSY
( P C V e r b i n d • Fehl)
Note:
• The explanations given in the [ ] are for servicemen.
• Words in brackets ( ) are german. A translated version for each market is available with this model series.
• The other party's fax machine is busy or has run out of recording paper. Try again.
• A recording paper jam occurred under the film cartridge. Clear the jammed paper.
[If the printout jams, please refer to Fig. a on the next page.]
• The unit is chacking that there is no slake on the film. Wait a while.
• The other party's fax machine dose not provide the polling function. Chack with the
other party.
• The other party's fax machine is busy or has run out of recording paper. Try again.
• The document is jammed. Remove the jammed document.
• Attempted to transmit a document longer than 600 mm. Press STOP to remove the
document. Divide the document into two or more sheets and try again.
[Alternatery, turn off service code #559 to enable sending of documents longer than
600 mm.]
• A transmission error occurred. Try again.
• The unit is too hot. Let the unit cool down.
[If many copies are nearly all black, this message will be displayed. When this occurs,
open the front cover and let the unit cool down.]
• There is no room left in memory to record a voice message. Erase some or all of the
message.
• Your TAD/FAX greeting message is not recorded. Record a greeting message.
• The voice guidance feature is set to "OFF". Modify the setting.
Pre-recorded greeting message will be adopted.
• The fax function cannot be operated by the PC. The RS232C cable is not connected
correctly, or the software is not running on the PC.
[If many copies are nearly all black, this message will be displayed. When this occurs,
open the front cover and let the unit cool down.]
CAUSE AND REMEDY
27
KX-FP320G / KX-FM330G