Setting Up; Installation Mode - Panasonic SOLID SHINE PT-VMZ51 Operating Instructions Manual

Setting up

Installation mode

There are four ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD]
(x page 90) depending on the installation mode.
Setting on a desk/floor and projecting forward
Menu item
[PROJECTION METHOD]
Mounting on the ceiling and projecting forward
Menu item
[PROJECTION METHOD]
Note
f The projector has a built-in angle sensor. The attitude of the projector is automatically detected by setting the [PROJECTOR SETUP] menu
→ [PROJECTION METHOD] to [AUTO]. For rear projection, set the [PROJECTION METHOD] to [REAR/DESK] or [REAR/CEILING].
rAngle sensor
The range of installation posture detected by the projector's built-in angle sensor is as follows.
[FRONT/DESK]
Chapter 2 Getting Started - Setting up
Method
[AUTO] or [FRONT/DESK]
Method
[AUTO] or [FRONT/CEILING]
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
30°
30°
:
Projection direction
Method
[REAR/DESK]
Method
[REAR/CEILING]
[FRONT/CEILING]
ENGLISH - 35