Panasonic SOLID SHINE PT-VMZ51 Operating Instructions Manual page 95

Operation
Press the w button.
Press the q button.
Setting the mute status
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [MUTE].
4) Press qw to switch the item.
[OFF]
[ON]
Setting the audio output during standby
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [IN STANDBY MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], audio cannot be output during
standby.
f When [IN STANDBY MODE] is set to [ON], you can adjust the volume with the <VOL-> button / <VOL+> button on the remote control or the
control panel during standby.
f When [IN STANDBY MODE] is set to [ON], even [QUICK STARTUP] is set to [ON], the power indicator <ON (G)/STANDBY (R)> will not
change to a red light when the specified time set in [VALID PERIOD] elapses.
Setting the audio input from the connected device
Choose the audio input terminal for each input signal.
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select the items of [AUDIO IN SELECT] to set.
[COMPUTER1]
[COMPUTER2]
[HDMI1]
[HDMI2]
[DIGITAL LINK]
[MEMORY VIEWER]
[NETWORK]
4) Press qw to switch the item.
f The sub items will switch each time you press the button.
[AUDIO IN 1]
[AUDIO IN 2]
Chapter 4 Settings - [PROJECTOR SETUP] menu
Adjustment
Increases the volume.
Decreases the volume.
Audio is output.
Audio is muted.
Disables audio output in the standby mode.
Enables audio output in the standby mode.
Set the audio output for COMPUTER1 input.
Set the audio output for COMPUTER2 input.
Set the audio output for HDMI1 input.
Set the audio output for HDMI2 input.
Set the audio output for DIGITAL LINK input.
Set the audio output for MEMORY VIEWER input.
Set the audio output for NETWORK input.
Audio connected to the <AUDIO IN 1> terminal is output during projection of image from the set input
terminal.
Audio connected to the <AUDIO IN 2> terminal is output during projection of image from the set input
terminal.
Range
0 ~ +63
ENGLISH - 95